...to Send (RTS), and Data Terminal Ready (DTR) pins. • A few things to keep in mind • When using an interface-powered converter, there are a few things to keep in mind, such as how much power is available from the RS-232 port—and how much power is dis...

...send the authentication request to the authenticator. The authenticator passes the request to the authentication server to authenticate and verify, and the server tells the authenticator if the request for authorization for those ports is granted.

...equipment —especially servers— generates a lot of heat in a relatively small area. Today’s servers are smaller and have faster CPUs than ever. Because most of the power used by these devices is dissipated into the air as heat, they can really stra...

...purchasing decision. • Check out our IT knowledgebase for indepth info about the latest technologies, pin-outs, etc. Find detailed, easy to understand application diagrammes. • Please find our "Server"  topics on the left side of this page.

...remote sites to access servers, logic controllers, or any devices that require programming. • Diagnostics. From your master control room, you can probe servers and run diagnostics. • Matrix Switches • Matrix switches enable more than one device to ...

...As workstations and servers migrated from ordinary 10-Mbps Ethernet to 100-Mbps speeds, it became clear that even greater speeds were needed. Gigabit Ethernet was developed for an even faster Ethernet standard to handle the network traffic gener...

...use this for connecting servers or interconnecting switches. Because the distance is very limited, you should use fibre optic cabling for your long-distance connections. • You may find RJ45 interfaces for 10 Gigabit equipment. That "standard" requir...

...networking equipment, servers, and patch panels, then a 4-post rack makes more sense because it provides more stable, 4-point mounting for deep equipment. For flexible mounting of both standard and extra-deep equipment, you can even get four-post ...